dl-Ephedrine synthesis from 1-Phenyl-1,2-propandion

G.Patton

Expert
Joined
Jul 5, 2021
Messages
2,704
Solutions
3
Reaction score
2,849
Points
113
Deals
1

Introduction

Here is described synthesis method of dl-Ephedrine from 1-Phenyl-1,2-propandion by means of catalytic reduction with hydrogen gas and Adams' catalyst. 1-Phenyl-1,2-propandion Can be purchased in international chemical market, other reagents are not so hard to buy. This is a one-pot reaction that uses gentle exposure to hydrogen gas. Pay attention to safety measures. Moreover, there are several simple methods of Ephedrine manufacturing such as Ephedrine extraction from plants, Synthesis of ephedrine from propiophenone, Methamphetamine from ephedrine tablets and Clean Green Ephedrine Manufacturing Process.​

Equipment and glassware:​

Reagents:​

  • Absolute ethyl alcohol ~150 mL;
  • 1-Phenyl-1,2-propandion (0.05 mole) 7.4 g;
  • Alcoholic solution of methylamine containing 1.6 g (0.05 mole);
  • Platinum oxide (PtO2; Adams' catalyst) 0.1 g;
  • Hydrogen chloride (HCl) alcoholic solution ~30 mL;
  • Acetone ~200 mL.
WaqusZ80Or

Soluble in H2O 47.62 g/L (25 ºC), alcohol, ether, chloroform, and oils;​
Boiling Point: 255 °C at 760 mm Hg (free base);
Melting point freebase: 37-39 ̊C;
Melting point HCI salt: 187-188 ̊C;
Molecular Weight: 165.236 g/mole;
Density: 1.124 g/cm3 (20 °C);
CAS Number: 299-42-3 (free base) and 50-98-6 (hydrochloride salt).


dl-Ephedrine hydrochloride synthesis procedure​

A mixture of 50 mL of absolute ethyl alcohol, 7.4 g of 1-Phenyl-1,2-propandion (0.05 mole) and an alcoholic solution of methylamine containing 1.6 g (0.05 mole) was reduced catalytically with hydrogen in the presence of 0.1 g of platinum oxide (PtO2) in 200 mL round bottom flask. In some experiments, there was a long induction period and then the yield was low. This behavior could be obviated by reducing the catalyst first and then adding the reactants. When reduction no longer proceeded, the catalyst was removed by filtration and about half the alcohol removed under reduced pressure. By this means, any excess of methylamine was removed. The solution was made just acid with alcoholic hydrogen chloride up to pH 6.5-7 and evaporated to dryness. The solid hydrochloride was washed with cold acetone and dried. A small amount of pseudoephedrine hydrochloride could be extracted from this by means of hot chloroform and by working up a number of extractions sufficient was obtained for definite identification (m.p. 164 °C; free base, m.p. 118 °C).​
WljO9AzCHE
The dl-Ephedrine hydrochloride was purified by recrystallizing once from alcohol-acetone and melted at 189 °C. The free base was recrystallized from chloroform-petroleum ether. The yield was 2.5-4.0 g (25-40 %).
 
Last edited by a moderator:

Re186

Don't buy from me
Resident
Language
🇺🇸
Joined
Feb 26, 2023
Messages
52
Reaction score
39
Points
18
I think it would be better to use platinum carbon catalyst for this reaction catalyst. On the one hand, platinum carbon has a low density and is easier to suspend in the solution. On the other hand, the platinum carbon catalyst uses a relatively large amount, which is easy to recycle and has a relatively low loss rate. What do you think?
 

mxtlrr_chem

Don't buy from me
Resident
Joined
Dec 29, 2022
Messages
18
Reaction score
5
Points
3
According to pubchem, 1-phenyl-1,2-propanedion[e] is found in coffee, however I havent been able to find any literature on extracting it. Does anyonenhave anything about extraction from coffee?
 

41Dxflatline

Don't buy from me
Resident
Joined
Dec 23, 2022
Messages
320
Solutions
1
Reaction score
157
Points
43
How much in coffee?
 

junjun

Don't buy from me
New Member
Joined
Aug 27, 2023
Messages
2
Reaction score
2
Points
1
Hello I want to ask if I have dl-Ephedrine can I get D methamphetamine through iodine red phosphorus or can I get DL methamphetamine
 

bb.puffs

Don't buy from me
New Member
Joined
Jul 11, 2024
Messages
1
Reaction score
0
Points
1
I believe you will get D meth but only from the l-ephedrine of the racemic precursor. So only half the ephedrine will become meth
 

Teotaita

Don't buy from me
Member
Joined
Mar 16, 2024
Messages
7
Reaction score
0
Points
1
What size is the filter paper?
 

G.Patton

Expert
Joined
Jul 5, 2021
Messages
2,704
Solutions
3
Reaction score
2,849
Points
113
Deals
1
you can use typical coffee filter or two of them at the same time if it's necessary
 

Teotaita

Don't buy from me
Member
Joined
Mar 16, 2024
Messages
7
Reaction score
0
Points
1
For the catalyst removal.
big thank you from me (Ewen)
 

Toti

Don't buy from me
Resident
Language
🇺🇸
Joined
May 23, 2024
Messages
7
Reaction score
1
Points
3
Hi @G.Patton

I wonder if there is a short way to go from (1-Phenyl-1,2-propandion"e")
To crystal methamphetamine that to go by stoping at converting (1-Phenyl-1,2-propandion"e") to ephedrine fisrt then crystal methamphetamine

My idea was can be shorter in time and less loss of yield

If so what do you recomend ?
Thank you
 

G.Patton

Expert
Joined
Jul 5, 2021
Messages
2,704
Solutions
3
Reaction score
2,849
Points
113
Deals
1
Hi, I don't know such way and think that it's impossible.
 

Toti

Don't buy from me
Resident
Language
🇺🇸
Joined
May 23, 2024
Messages
7
Reaction score
1
Points
3
Thank you for your information
 

WalterFan

Don't buy from me
Resident
Language
🇺🇸
Joined
Jul 4, 2024
Messages
23
Reaction score
8
Points
3
Forgive my ignorance, the part that ‘there was a long induction period and then the yield was low. This behavior could be obviated by reducing the catalyst first and then adding the reactants. ‘ I just don’t get it how to obviate the long induction period by reducing the catalyst, the catalyst is platinum oxide, before adding it to the mixture, how to reduce it first ? It is some black liquid, how should I work it out ?
 
Top